Skip to main content
SpringerLink
Log in

Wave and fracture propagation in continuum and faulted rock masses: distinct element modeling

  • Original Paper
  • Published:
Arabian Journal of Geosciences Aims and scope Submit manuscript

Abstract

In this study, to investigate the dynamic fracture mechanism of blast-induced fracturing of rock mass around a blasthoe, two-dimensional (2D) distinct element method was used. The dynamic stresses, material status, and velocity vectors are shown to investigate rock mass failure subjected to blast load. On the other hand, rock masses consist of intact rock and discontinuities such as faults, joints, and bedding planes. The presence of such discontinuities in rock masses dominates the response of jointed rock masses to static and dynamic loading. This paper focuses on the effect of fault orientation on dynamic fracturing of rock mass. In order to investigate the effect of faults on dynamic fracturing of rock mass, a numerical simulation was conducted. The two-dimensional (2D) distinct element code was used to simulate the effect of a fault on rock failure and stress distribution through the rock mass due to blast wave propagation. The blast loading history was calculated using analytical method and was applied to the blasthole walls. Accordingly, the interaction of explosive energy transferred to the rock mass from the blasthole was examined as a function of distance to the fault plane. A Mohr–Coulomb material model was used for host rock to allow for plastic failure calculations. The study can be divided in two parts: firstly, surface blast and secondly, underground blast. The conducted numerical study describes the role of fault in blasting in a qualitative manner. On the other hand, a free-face boundary was considered as a common blast operation which is conducted in surface mining. In second part, blast was modeled in underground operations at presence of in situ stresses. The results in such areas showed predominant effect of pre-stresses as well as fault orientation on fracture propagation.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14

Similar content being viewed by others

References

  • Bedford A, Drumheller DS (1994) Introduction to elastic wave propagation. Wiley, Chichester

    Google Scholar 

  • Brinkman JR (1989) Separating shock waves and gas expansion breakage mechanisms. In: Proceedings of FRAGBLAST2. Keystone, Colo, p 6–15

  • Chen SG, Zhao J (1998) A study of UDEC modeling for blast wave propagation in jointed rock masses. Int J Rock Mech Min Sci 35(1):93–99

    Article  Google Scholar 

  • Chen SG, Cai JG, Zhao J, Zhou YX (2000) Discrete element modelling of an underground explosion in a jointed rock mass. Geotech Geol Eng 18:59–78

    Article  Google Scholar 

  • Cho SH, Kaneko K (2004) Influence of the applied pressure waveform on the dynamic fracture processes in rock. Int J Rock Mech Min Sci 41:771–784

    Article  Google Scholar 

  • Coates RT, Schoenberg M (1995) Finite difference modeling of faults and fractures. Geophysics 60(5):1514–1526

    Article  Google Scholar 

  • Cundall PA (1990) Numerical modelling of jointed and faulted rock. In: Rossmanith HP (ed) Mechanics of jointed and faulted rock. A.A. Balkema, Rotterdam

    Google Scholar 

  • Danell RE, Leung L (1987) Computer simulation of blast fracture and fragmentation of rocks. FRAGBLAST2. Keystone, Colorado

  • Desai CS, Zaman MM, Lightner JG, Siriwardane HJ (1984) Thin-layer element for interfaces and joints. Int J Num Anal Methods Geomech 8:19–43

    Article  Google Scholar 

  • Donze FV, Bouchez J, Magnier SA (1997) Modeling fractures in rock blasting. Int J Rock Mech Min Sci 34:1153–1163

    Article  Google Scholar 

  • Goodman RE (1976) Methods of geological engineering in discontinuous rocks. West Publishing, St. Paul

    Google Scholar 

  • Goodman RE, Taylor L, Brekke TL (1968) A model for the mechanics of jointed rock. J Soil Mech Found Div, ASCE 94(SM3):637–659

    Google Scholar 

  • Grady DE, Kipp ME (1980) Continum modeling of explosive fracture in oil shale. Int J Rock Mech Min Sci 17:147–157

    Article  Google Scholar 

  • Hao YH (2003) Numerical modeling of the effect of faults on large-scale underground cavern. Division of engineering geology and hydrogeology, RWTH, Aachen

    Google Scholar 

  • Hart RD (1993) An introduction to distinct element modelling for rock engineering. In: Hudson JA (ed) Comprehensive Rock Engineering. Vol. 2. p 245–61

  • Hudson JA, Harrison JP (1997) Engineering rock mechanics—an introduction to the principles. Oxford: Pergamon

  • Jensen RP, Preece DS (1999) Modeling explosive/rock interaction during presplitting using ALE computation methods. In: Proceedings of the sixth international symposium on rock fragmentation by blasting. The South African Institute of Mining and Metallurgy, p 199–202

  • Lei WD (2005) Numerical studies on 2-D compressional wave propagation in jointed rock masses [D]. Nanyang Technological University, Singapore

    Google Scholar 

  • Lopez E (1997) Drilling and blasting of rocks. Project director for EPM, S.A, printed in The Netherlands

  • Ma GW, An XM (2008) Numerical simulation of blasting-induced rock fractures. Int J Rock Mech Min Sci 45:966–975

    Article  Google Scholar 

  • Ma GW, Hao H, Zhou YX (1998) Modeling of wave propagation induced by underground explosion. Comput Geotech 22:283–303

    Article  Google Scholar 

  • Ma K, Tang CA, Li LC, Ranjith PG, Cai M, Xu NW (2013) 3D modeling of stratified and irregularly jointed rock slope and its progressive failure. Arab J Geosci 6:2147–2163

    Article  Google Scholar 

  • Mchugh S (1983) Crack extension caused by internal gas pressure compared with extension caused by tensile stress. Int J Fract 21:163–176

    Article  Google Scholar 

  • Minchinton A, Lynch PM (1996) Fragmentation and heave modeling using a coupled discrete element gas flow code. In: Mohanty B (ed) Proceedings of the FRAGBLAST5. Balkema, Rotterdam, pp 71–80

    Google Scholar 

  • Mortazavi A, Katsabanis PD (2001) Modelling burden size and strata dip effects on the surface blasting process. Int J Rock Mech Min Sci 38:481–498

    Article  Google Scholar 

  • Mortazavi A, Molladavoodi H (2012) A numerical investigation of brittle rock damage model in deep underground openings. Engng Fract Mech 90:101–120

    Article  Google Scholar 

  • Munjiza A, Latham JP, Andrews KRF (1999) Rock fracture and fragmentation model in coupled analysis of explosive induced rock fragmentation. In: Proceedings of the sixth international symposium on rock fragmentation by blasting. The South African Institute of Mining and Metallurgy, p 187–90

  • Nilson RH, Proffer WJ, Duff RE (1985) Modeling of gas-driven fractures induced by propellant combustion within an explosion cavity. Int J Rock Mech Min Sci 22:3–19

    Article  Google Scholar 

  • Ning Y, Yang J, An X, Ma G (2011) Modelling rock fracturing and blast-induced rock mass failure via advanced discretisation within the discontinuous deformation analysis framework. Comput Geotech 38:40–49

    Article  Google Scholar 

  • Paine AS, Please CP (1994) An improved model of fracture propagation by gas during rock blasting-some analytical results. Int J Rock Mech Min Sci 31:699–706

    Article  Google Scholar 

  • Salari-Rad H, Mohitazar M, Rahimi Dizadji M (2013) Distinct element simulation of ultimate bearing capacity in jointed rock foundations. Arab J Geosci. doi:10.1007/s12517-012-0667-6

    Google Scholar 

  • Sazid M, Singh TN (2012) Two-dimensional dynamic finite element simulation of rock blasting. Arab J Geosci. doi:10.1007/s12517-012-0632-4

    Google Scholar 

  • Sharifzadeh M, Karegar S, Ghorbani M (2013) Influence of rock mass properties on tunnel inflow using hydromechanical numerical study. Arab J Geosci 6:169–175

    Article  Google Scholar 

  • Sitharam TG, Sridevi J, Shimizu N (2001) Practical equivalent continuum characterization of jointed rock masses. Int J Rock Mech Min Sci 38(3):437–448

    Article  Google Scholar 

  • Starfield AM, Pugliese JM (1968) Compressional waves generated in rock by cylindrical explosive charges: a comparison between a computer model and field measurements. Int J Rock Mech Min Sci 5:65-77

    Google Scholar 

  • Verma AK, Singh TN (2010) Modeling of a jointed rock mass under triaxial conditions. Arab J Geosci 3:91–103

    Article  Google Scholar 

  • Verma AK, Bajpai RK, Singh TN, Narayan PK, Dutt A (2011) 3D instability analysis of an underground geological repository-an Indian case study. Arab J Geosci 4:1173–1188

    Article  Google Scholar 

  • Wang ZL, Li YC, Shen RF (2007) Numerical simulation of tensile damage and blast crater in brittle rock due to underground explosion. Int J Rock Mech Min Sci 44(5):730–738

    Article  Google Scholar 

  • Wang ZL, Konietzky H, Shen RF (2009) Coupled finite element and discrete element method for underground blast in faulted rock masses. Soil Dyn Earth Eng 29:939–945

    Article  Google Scholar 

  • Wyliie DC, Mah CW (2005) Rock slope engineering, 4th edn. Taylor & Francis, London

    Google Scholar 

  • Xia X, Li HB, Li JC, Liu B, Yu C (2013) A case study on rock damage prediction and control method for underground tunnels subjected to adjacent excavation blasting. Tunn Undergr Space Tech 35:1–7

    Article  Google Scholar 

  • Zhang YH, Fu XD, Sheng Q, Leng XL (2012) Study on elastic P-wave propagation law in unfavorable geologic structures with discontinuous deformation analysis method. Arab J Geosci. doi:10.1007/s12517-012-0773-5

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Mining Engineering Department, Amirkabir University of Technology, Tehran, Iran

    Zeinab Aliabadian, Ali Mortazavi & Parviz Maarefvand

  2. Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran

    Mansour Sharafisafa

Authors
  1. Zeinab Aliabadian
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Mansour Sharafisafa
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Ali Mortazavi
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Parviz Maarefvand
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Mansour Sharafisafa.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Aliabadian, Z., Sharafisafa, M., Mortazavi, A. et al. Wave and fracture propagation in continuum and faulted rock masses: distinct element modeling. Arab J Geosci 7, 5021–5035 (2014). https://doi.org/10.1007/s12517-013-1155-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12517-013-1155-3

Keywords

Search

Navigation