Abstract
Responsible for 17% of all energy consumption and 16% of greenhouse gas (GHG) emissions in Canada, the residential sector presents substantial opportunities for reducing both energy consumption and GHG emissions. Being one of the highest per capita energy consumers in the world, there is increasing pressure on Canada to reduce both. Amongst the numerous options to reduce energy consumption in the residential sector is the large-scale adoption of active and passive solar technologies in the Canadian housing stock (CHS). In earlier publications, the authors have investigated the techno-economic feasibility of large-scale adoption of window and glazing modifications, window shading devices and solar domestic hot water systems in the CHS as retrofit measures. In this paper, the focus is on the adoption of thermal storage using phase change material (PCM) in the CHS as a retrofit measure. The results indicate that applying PCMs with melting temperature of 23°C to the eligible houses reduce energy consumption GHG emissions of the Canadian housing stock by about 2.5%. The economic feasibility results demonstrate the impact of fuel costs, as well as interest and energy price escalation rates on payback period. The economic results indicate that upgrading houses to incorporate PCM storage in the province of New Brunswick is more feasible than other provinces.
Similar content being viewed by others
References
Almeida F, Zhang D, Fung AS, Leong WH (2010). Investigation of multilayered phase-change-material modeling in ESP-R. In: Proceedings of 1st International High Performance Buildings Conference, West Lafayette, USA.
Arumi F, Hourmanesh M (1977). Energy performance of solar walls: A computer analysis. Energy and Buildings, 1: 167–174.
Aste N, Angelotti A, Buzzetti M (2009). The influence of the external walls thermal inertia on the energy performance of well insulated buildings. Energy and Buildings, 41: 1181–1187.
Athienitis A, Liu C, Hawes D, Banu D, Feldman D (1997). Investigation of the thermal performance of a passive solar test-room with wall latent heat storage. Building and Environment, 32: 405–410.
Balaras CA (1996). The role of thermal mass on the cooling load of buildings. An overview of computational methods. Energy and Buildings, 24: 1–10.
Balcomb JD, Hedstrom JC, McFarland RD (1977). Simulation analysis of passive solar heated buildings—Preliminary results. Solar Energy, 19: 277–282.
Bank of Canada (BOC) (2014). Retrieved from http://www.bankofcanada.ca/. Accessed 21 Feb. 2014.
Beausoleil-Morrison I (2000). AIM-2 Implementation into ESP-r. Natural Resources Canada. Unpublished document.
Beausoleil-Morrison I, Mitalas G (1997). BASESIMP: A residential-foundation heat-loss algorithm for incorporating into whole-building energy-analysis programs. In: Proceedings of International IBPSA Conference, Prague, Czech Republic.
Brown MJ (1990). Optimization of thermal mass in commercial building applications. ASME Journal of Solar Energy Engineering, 112: 273–279.
Burch D, Malcolm S, Davis K (1984). The effect of wall mass on the summer space cooling of six test buildings. AHRAE Transactions, 90(2B): 5–21.
Clarke JA (2001). Energy Simulation in Building Design. Oxford, UK: Butterworth-Heinemann.
CMHC (2007). Residential solar mass wall analysis for Canada. Research Highlight, Technical Series 07-124.
Crawley DB, Hand JW, Kummert M, Griffith BT (2008). Contrasting the capabilities of building energy performance simulation programs. Building and Environment, 43: 661–673.
Dodoo A, Gustavsson L, Sathre R (2012). Effect of thermal mass on life cycle primary energy balances of a concrete- and a wood-framed building. Applied Energy, 92: 462–472.
Duffin RJ, Knowles G (1985). A simple design method for the Trombe wall. Solar Energy, 34: 69–72.
ESRU (2014). Energy Systems Research Unit (ESRU). Available at http://www.esru.strath.ac.uk. Accessed 21 Feb. 2014.
Farhat AAM, Ugursal VI (2010). Greenhouse gas emission intensityfactors for marginal electricity generation in Canada. International Journal of Energy Research, 34: 1309–1327.
Farid MM, Khudhair AM, Razack AAK, Al-Hallaj S (2004). A review on phase change energy storage: Materials and applications. Energy Conversion and Management, 45: 1597–1615.
Gordon JM, Zarmi Y (1981b). Analytical model for passively-heated solar houses—II. Users guide. Solar Energy, 27: 343–347.
Gordon JM, Zarmi Y (1981a). Analytical model for passively-heated solar houses—I. Theory. Solar Energy, 27: 331–342.
Gregory K, Moghtaderi B, Sugo H, Page A (2008). Effect of thermal mass on the thermal performance of various Australian residential constructions systems. Energy and Buildings, 40: 459–465.
Hand JW (1998). Removing barriers to the use of simulation in the building design professions. PhD Dissertation, University of Strathclyde, UK.
Hawes DW, Feldman D, Banu D (1993). Latent heat storage in building materials. Energy and Buildings, 20: 77–86.
Heim D (2005). Two simulation methods of heat transfer with phase change within whole building dynamic simulation. In: Proceedings of 9th International IBPSA Conference, Montreal, Canada, pp. 459–466.
Heim D (2006). Phase-change material modeling within whole building dynamic simulation. ASHRAE Transactions, 112(2): 518–525.
Heim D, Clarke JA (2004). Numerical modelling and thermal simulation of PCM-gypsum composites with ESP-r. Energy and Buildings, 36: 795–805.
Hydro-Quebec (2011). Comparison of electricity prices in major North American cities. Retrieved from http://www.hydroquebec.com/publications/en/comparison_prices/pdf/comp_2011_en.pdf. Accessed 21 Feb. 2014.
Jeon J, Lee JH, Seo J, Jeong SG, Kim S (2013). Application of PCM thermal energy storage system to reduce building energy consumption. Journal of Thermal Analysis and Calorimetry, 111: 279–288.
Karlsson J, Wadsérg M (2013). A conceptual model that simulates the influence of thermal inertia in building structures. Energy and Buildings, 60: 146–151.
Kelly NJ (1998). Towards a design environment for building integrated energy systems: The integration of electrical power flow modeling with building simulation. PhD Dissertation, University of Strathclyde, UK.
Kossecka E, Kosny J (2002). Influence of insulation configuration on heating and cooling loads in a continuously used building. Energy and Buildings, 34: 321–331.
Lane GA (1983). Solar Heat Storage: Latent Heat Materials. Boca Raton, USA: CRC Press.
Nakhi AE (1995). Adaptive construction modelling within whole building dynamic simulation. PhD Dissertation, University of Strathclyde, UK.
National energy board of Canada (NEB) (2014). Retrieved from http://www.neb-one.gc.ca/clf-nsi/rnrgynfmtn/prcng/prcng-eng.html. Accessed 21 Feb. 2014.
Nikoofard S (2012). Techno-economic assessment of solar technologies and integration strategies for the Canadian housing stock. PhD Dissertation, Dalhousie University, Canada.
Nikoofard S, Ugursal VI, Beausoleil-Morrison I (2014a). Technoeconomic assessment of the impact of window shading retrofits on the heating and cooling energy consumption and GHG emissions of the Canadian Housing Stock. Journal of Energy and Buildings, 69, 354–366.
Nikoofard S, Ugursal VI, Beausoleil-Morrison I (2014b). An investigation of the technoeconomic feasibility of solar domestic hot water heating for the Canadian housing stock. Journal of Solar Energy, 101: 308–320.
Nikoofard S, Ugursal VI, Beausoleil-Morrison I (2014c). Economic analysis of energy upgrades based on tolerable capital cost. Journal of Energy Engineering, DOI: 10.1061/(ASCE)EY.1943-7897.0000203.
Nova Scotia Department of Energy (2011). Retrieved from http://www.gov.ns.ca/energy/consumer-information/energy-prices/propane.asp. Accessed 21 Feb. 2014.
OEE (2007). Energy Efficiency Trends in Canada, 1990 to 2007. Office of Energy Efficiency, Natural Resources Canada, Ottawa, Canada.
Ogoli DM (2003). Predicting indoor temperatures in closed buildings with high thermal mass. Energy and Buildings, 35: 851–862.
Pasupathy A, Velraj R, Seeniraj RV (2008). Phase change material-based building architecture for thermal management in residential and commercial establishments. Journal of Renewable and Sustainable Energy Reviews, 12: 39–64.
Peppio K, Kauranen P, Lund PD (1991). A multicomponent PCM wall optimized for passive solar heating. Energy and Buildings, 17: 259–270.
Pilon L (2014). Thermal properties of phase change materials (PCMs). Retrieved from http://www.seas.ucla.edu/~pilon/downloads.htm#section4. Accessed 7 Sept. 2014.
Purdy J, Beausoleil-Morrison I (2001). The significant factors in modeling residential buildings. In: Proceedings of 7th International IBPSA Conference, Rio de Janeiro, Brazil, pp. 207–214.
Robbins FV, Spillman CK (1980). Computer modeling of a ventilated Trombe wall—With actual performance results. Solar Energy, 25: 207–213.
Ruud MD, Mitchell JW, Klein SA (1990). Use of building thermal mass to offset cooling loads. ASHRAE Transactions, 96(2): 1028–1038.
Siddiqui O, Fung A, Zhang D (2008). Modeling of phase change materials in the Toronto SUI net zero energy house using TRNSYS. In: Proceedings 3rd Canadian Solar Buildings Conference, Fredericton, Canada.
Smolec W, Thomas A (1991). Some aspects of Trombe wall heat transfer models. Energy Conversion and Management, 32: 269–277.
Statistics Canada (2011). Statistics Canada Handbook for the Average of 2011. Retrieved from http://www.statcan.gc.ca/pub/57-601-x/2011002/t186-eng.htm. Accessed 21 Feb. 2014.
Strachan PA, Kokogiannakis G, Macdonald IA (2008). History and development of validation with the ESP-r simulation program. Building and Environment, 43: 601–609.
Swan L (2010). Residential sector energy and GHG emissions model for the assessment of new technologies. PhD Dissertation, Dalhousie University, Canada.
Swan L, Ugursal VI, Beausoleil-Morrison I (2008). A new hybrid end-use energy and emissions model of the Canadian housing stock. In: Proceedings of 3rd Canadian Solar Buildings Conference, Fredericton, Canada.
Swan L, Ugursal VI, Beausoleil-Morrison I (2009). A database of house descriptions representative of the Canadian housing stock for coupling to building energy performance simulation. Journal Building Performance Simulation, 2: 75–84.
Swan L, Ugursal VI, Beausoleil-Morrison I (2013). Hybrid residential end-use energy and GHG emissions model—Development and verification for Canada. Journal of Building Performance Simulation, 6: 1–23.
Tasdemiroglu E (1985). Comparison of an analytical model with experimental results for a passive thermal storage wall. Solar Energy, 35: 283–286.
The World Bank (2014). Available at http://data.worldbank.org/. Accessed 21 Feb. 2014.
Trombe F, Robert JF, Cabanat M, Sesolis B (1977). Concrete walls to collect and hold heat. Solar Age, 2(8): 13–19.
Tyagi VV, Buddhi D (2007). PCM thermal storage in buildings: A state of art. Renewable and Sustainable Energy Reviews, 11: 1146–1166.
USDOE (2013). Building energy software tools directory: ESP-r. Energy Efficiency and Renewable Energy. Available at http://apps1.eere.energy.gov/buildings/tools_directory/software.cfm/ID=39/pagename=alpha_list. Accessed 10 Nov. 2013.
Walker IS, Wilson DJ (1990). The Alberta air infiltration model: AIM-2. University of Alberta, Deptartment of Mechanical Engineering, Report 71, Edmonton, Canada.
Wang W, Beausoleil-Morrison I, Reardon J (2009). Evaluation of the Alberta air infiltration model using measurements and inter-model comparisons. Building and Environment, 44: 309–318.
Whole Building Design Guide (WBDG) (2014). Energy Escalation Rate Calculator (EERC). Retrieved from http://www.wbdg.org/tools/eerc.php?c=8. Accessed 21 Feb. 2014.
Yedder RB, Bilgen E (1991). Natural convection and conduction in Trombe wall systems. International Journal of Heat and Mass Transfer, 34: 1237–1248.
Zhang D, Fung AS, Siddiqui O (2008). Finite element modeling for integrated solid-solid PCM-building material with varying phase change temperatures. In: Proceedings of 3rd Canadian Solar Buildings Conference, Fredericton, Canada.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Nikoofard, S., Ugursal, V.I. & Beausoleil-Morrison, I. Techno-economic assessment of the impact of phase change material thermal storage on the energy consumption and GHG emissions of the Canadian Housing Stock. Build. Simul. 8, 225–238 (2015). https://doi.org/10.1007/s12273-014-0204-5
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12273-014-0204-5