Abstract
Formation testing while drilling is an innovative technique that is replacing conventional pressure testing in which the fluid sampling is conducted in a relatively short time following the drilling. At this time, mud invasion has just started, mudcake has not formed entirely and the formation pressure is not stable. Therefore, it is important to study the influence of the downhole dynamic environment on pressure testing and fluid sampling. This paper applies an oil-water two phase finite element model to study the influence of mudcake quality and mud filtrate invasion on supercharge pressure, pretest and sampling in the reservoirs of different permeability. However, the study is only for the cases with water based mud in the wellbore. The results illustrate that the mudcake quality has a significant influence on the supercharge pressure and fluid sampling, while the level of mud filtrate invasion has a strong impact on pressure testing and sampling. In addition, in-situ formation pressure testing is more difficult in low permeability reservoirs as the mud filtrate invasion is deeper and therefore degrades the quality of fluid sampling. Finally, a field example from an oil field on the Alaskan North Slope is presented to validate the numerical studies of the effects of downhole dynamic conditions on formation testing while drilling.
Article PDF
Similar content being viewed by others
References
Di D J, Tao G, Wang H, et al. Finite element simulation of wireline formation tester applied in fractured reservoir. The Open Petroleum Engineering Journal. 2012a. 5(1): 138–145
Di D J, Tao G, Sun H F, et al. Analysis and consideration of formation testing while drilling technology. Well Logging Technology. 2012b. 36(3): 294–299 (in Chinese)
Di D J, Tao G and Ye Q. Feasibility study on application of wireline formation testing to low permeability reservoirs. Progress in Geophysics. 2012c. 27(6): 2518–2525 (in Chinese)
Fey S, Fareed A, Mansur H, et al. Reducing the risks and costs of highly deviated and extended reach drilling through the application of formation pressure while drilling. Paper SPE 141487 presented at the SPE Europe/EAGE Annual Conference and Exhibition held in Vienna, Austria, 23–26 May 2011
Finneran J M, Green C, Roed H, et al. Formation tester while drilling experience in Caspian development projects. Paper SPE 967819 presented at the SPE Annual Technical Conference and Exhibition held in Dallas, Texas, USA, 9–12 October 2005
Gu N, Tao G and Liu S M. Responses of the wireline formation tester in permeability anisotropic formations. Chinese Journal of Geophysics. 2005a. 48(1): 229–234 (in Chinese)
Gu N, Tao G and Liu S M. The finite element simulation of wireline formation testing for oil-water two-phase flow. Progress in Geophysics. 2005b. 20(2): 337–341 (in Chinese)
Gu N, Tao G and Liu S M. Three-dimensional finite element modeling of oil-water two-phase profiles in the wireline formation test. Geophysics. 2007. (4): 429–435
Hou X R, Liu Y F and Hao L J. Formation pressure testing in dynamic drilling environments. Foreign Oilfield Engineering. 2005. 21(2): 13–18 (in Chinese)
Lee H, Proett M, Weintraub P, et al. Results of laboratory experiments to simulate the downhole environment of formation testing while drilling. SPWLA 45th Annual Logging Symposium, June 6–9, 2004
Lee J and Kasap E. Fluid sampling from damaged formations. Paper SPE 39817 presented at the 1998 SPE Permian Basin Oil and Gas Recovery Conference held in Midland, Texas, 25–27 March 1998
Li M G, Wan C G and Bai B Z. Present situation and application prospect of pressure survey while drilling. Fault-Block Oil & Gas Field. 2008. 15(6): 123–126 (in Chinese)
Liu J L, Chen H N and Gao B T. Foreign measurement system for formation pressure while drilling and its application. Oil Drilling & Production Technology. 2010. 32(1): 94–98 (in Chinese)
Masoud R, Gyllensten A, Amari, K, et al. Using formation-testing -while-drilling pressures optimize a Middle East carbonate reservoir drilling program. Paper SPE 120715 presented at the 2009 SPE Middle East Oil & Gas Show and Conference held in the Bahrain International Exhibition Centre, Kingdom of Bahrain, 15–18 March 2009
Pop J, Laastad H and Eriksen K O. Operation aspects of formation pressure measurements while drilling. Paper SPE/IADC 92494 presented at the SPE/IADC Drilling Conference held in Amsterdam, The Netherlands, 23–25 February 2005
Proett M, Walker M, Welshans D, et al. Formation testing while drilling, a new era in formation testing. Paper SPE 84087 presented at the SPE Annual Technical Conference and Exhibition held in Denver, Colorado, USA, 5–8 October 2003
Proett M, Fogal J, Welshans D, et al. Formation pressure testing in the dynamic drilling environment. Paper SPE 87090 presented at the SPE Annual Technical Conference and Exhibition held in Dallas, Texas, USA, 2–4 March 2004
Proett M, Welshans D, Sherrill K, et al. Formation testing goes back to the future. SPWLA 51th Annual Logging Symposium held in Perth, Australia, 19–23 June 2010
Proett M, Eyuboglu S, Wilson J, et al. New sampling and testing-while-drilling technology, a safe, cost-effective alternative. Paper SPE/IADC 140337 presented at the SPE/IADC Drilling Conference and Exhibition held in Amsterdam, The Netherlands, 1–3 March 2011
Ren F G and Ma J G. Technique of formation pressure testing while drilling and its application. Well Logging Technology. 2005. 29(4): 385–387 (in Chinese)
Sarkar A K, Lee J and Kasap E. Adverse effect of poor mudcake quality: a supercharging and fluid sampling study. Paper SPE 48958 presented at the 1998 SPE Annual Technical Conference and Exhibition held in New Orleans, Louisiana, 27–30 September 1998
Seifert D J, Al-Dossari S, Burinda B J, et al. Application for formation testing while drilling in the Middle East. Paper SPE 93392 presented at the 14 SPE Middle East Oil & Gas Show and Conference held in Bahrain International Exhibition Centre, Bahrain, 12–15 March 2005
Su Y N and Dou X R. MWD & LWD and logging tools. Oil Drilling & Production Technology. 2005. 27(1): 74–78 (in Chinese)
Wang H, Tao G and Zhang X J. Review on the development of sonic logging while drilling. Well Logging Technology. 2009. 33(3): 197–203 (in Chinese)
Yang L and Tian S B. New style tool of pressure tester while drilling. Foreign Oil Field Engineering. 2005. 21(11): 20–23 (in Chinese)
Yi S G, Wu X L and Jin Z W. A study of numerical simulation of pressure response of wireline formation tester. Well Logging Technology. 1997. 21(5): 16–20 (in Chinese)
Zhang X Y, Guo Y J and Wang J N. The logging while drilling: past, present and future. Well Logging Technology. 2006. 30(6): 487–492 (in Chinese)
Zhao Z X, Han Y, Gao X, et al. SDC-I pressure tester while drilling. China Petroleum Machinery. 2011. 39(2): 52–54 (in Chinese)
Zhou B, Tao G and Diao S. Approximate analytic solution to pressure of the wireline formation tester considering flow line storage effect. Well Logging Technology. 2003. 25(1): 27–29 (in Chinese)
Zhou B, Mo X W and Tao G. The numerical simulation of wireline formation tester with finite element method. Journal of Jilin University: Earth Science Edition. 2007. 37(3): 629–632 (in Chinese)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Di, D., Tao, G., Wang, B. et al. Numerical analysis of the effects of downhole dynamic conditions on formation testing while drilling. Pet. Sci. 11, 391–400 (2014). https://doi.org/10.1007/s12182-014-0353-2
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12182-014-0353-2