The schematic diagram of a two-stage hybrid piston power machine with liquid piston in the second stage, which maintains gas compression up to pressures of 10 MPa, is presented. On the basis of the equations of conservation of flow and energy, a method for he calculation of compression and discharge processes is developed. Analytical expressions are obtained for determining the flow rates of the liquid in the second stageand in the gas cap as well as the fluid pressures at characteristic points of the system. Certification of the new technique is performed and the working processes that take place in the hydraulic part of a two-stage hybrid piston power machine are analyzed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
V. E. Shcherba, A. P. Bolshtyanskii, V. V. Shalai, and E. V. Khodyreva, Pump Compressors. Working Processes and Design Fundamentals [in Russian], Mashinostroenie, Moscow (2013).
V. E. Shcherba, A. P. Bolshtyanskii, S. Yu. Kaigorodov, and D. A. Kuzeeva, Analysis of basic advantages realized by combining positive-displacement compressors and pumps into a unified machine, Vest. Mashinostroenie, No. 12, 15−19 (2015).
V. E. Shcherba, V. V. Shalai, and A. V. Grigor’ev, Analysis of the influence of discharge pressure in the compressor section on the working processes and characteristic of a hybrid piston power machine with stepwise-type slot seal, Izv. Vyss. Ucheb. Zaved. Mashinostroenie, No. 4 (697), 49−57 (2018).
V. E. Shcherba, V. V. Shalai, A. V. Grigor’ev, et al., Analysis of theoretical and experimental results on the influence of discharge pressure in the pump section on the working processes and characteristic of a hybrid piston power machine stepwise-type slot seal, Zh. Sibirsk. Federal. Un-ta. Tekhnika i Tekhnologii, 11, No. 5, 591−603 (2018).
V. E. Shcherba, Theory, Design, and Construction of Positive-Displacement Piston Compressors. Textbook [in Russian], Yurayt, Moscow (2019).
I. E. Idel’chik, Textbook on Hydraulic Resistances [in Russian], M. O. Shteynberg, ed., Mashinostroenie, Moscow (1992).
P. I. Plastinin, Piston Compressors, vol. 1 [in Russian], KolosS, Moscow (2006).
A. D. Al’tshul’ and P. G. Kiselev, Hydraulics and Hydrodynamics [in Russian], Stroiizdat, Moscow (1975).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, Vol. 55, No. 8, pp. 15–20, August, 2019.
Rights and permissions
About this article
Cite this article
Shcherba, V.E., Zanin, A.V., Nosov, E.Y. et al. Calculation of Compression and Discharge Processes in a Two-Stage Hybrid Piston Power Machine with Liquid Piston. Chem Petrol Eng 55, 632–641 (2019). https://doi.org/10.1007/s10556-019-00672-z
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-019-00672-z