Skip to main content
SpringerLink
Log in

Optimization of Design and Operational Parameters of Adsorbers for Purification of Neon-Helium Mixture

  • Published:
Chemical and Petroleum Engineering Aims and scope

The analysis of options for arranging an adsorber composed of several sections is given. The formulas for calculating the geometric parameters of individual adsorber elements were obtained for a specified diameter of the cooling nitrogen bath. The expenditure of refrigerant and energy required to regenerate the sorbent were defined for several constructional variants. The operating costs for a single adsorber cycle were calculated. The optimum regeneration temperature was determined at which the cost of purifying the mixture is minimal.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10

Similar content being viewed by others

References

  1. V. L. Bondarenko, Yu. M. Simonenko, O. V. Diachenko, et al. “Problems of Quality Check While Producing Helium 99.9999%,” Proc. 8 Int. Conf. Cryogenics 2004, Prague (2004), pp. 184–188.

  2. V. L. Bondarenko, Yu. M. Simonenko, I. A. Losyakov, et al. “The influence of the geometric dimensions of the stationary sorbent bed on the effectiveness of periodic purification of inert gases,” Kholod. Tekhn. Tekhnol., 3, No. 125, 12–22 (2010).

    Google Scholar 

  3. V. L. Bondarenko, Yu. M. Simonenko, I. A. Losyakov, et al. “Optimization of geometry of adsorbers used in technologies for the purification of rare gases,” Tekh. Gazy, 5, 12–23 (2010).

    Google Scholar 

  4. A. M. Arkharov, V. L. Bondarenko, Yu. M. Simonenko, et al. “Unconventional technologies for concentrating the Ne-20 isotope,” Vest. MGTU, Spec. Iss., Kholod., Criog. Tekhn., Sist. Kondits. Zhizneobesp. (2005), pp. 33–42.

Download references

Author information

Authors and Affiliations

  1. Bauman Moscow State Technical University, Moscow, Russia

    V. L. Bondarenko

  2. Odessa National Academy of Food Technologies, Odessa, Ukraine

    Yu. M. Simonenko

  3. Krioin Engineering Company, Odessa, Ukraine

    A. A. Chigrin

Authors
  1. V. L. Bondarenko
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Yu. M. Simonenko
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. A. A. Chigrin
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Yu. M. Simonenko.

Additional information

Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, No. 10, pp. 23–27, October, 2015.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Bondarenko, V.L., Simonenko, Y.M. & Chigrin, A.A. Optimization of Design and Operational Parameters of Adsorbers for Purification of Neon-Helium Mixture. Chem Petrol Eng 51, 683–690 (2016). https://doi.org/10.1007/s10556-016-0105-9

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10556-016-0105-9

Keywords

Search

Navigation