Abstract
The Arakli tunnel is located in the eastern Black Sea region where the most mass movement is observed in Turkey. Following the tunnel entrance portal excavations in basaltic tuffs on nearby the Konakonu residential area, an impending failure occurred. Because of the developed tension cracks and deformations on the ground, five houses and their gardens were damaged completely. The present study aims to investigate the mechanism of the failure. In order to do this, kinematic, limit equilibrium, and numerical stability analyses were carried out. Firstly, the kinematic analyses were performed taking into account the main joint sets for the slopes. The results of the kinematic analyses showed that planar and wedge failures were possible on the portal slope and no failure occurred on the cut slope. However, the limit equilibrium analysis showed that neither the planar nor wedge failures were expected to occur on the portal slope. The numerical stability analyses were performed to determine if circular failure is to occur in the slopes. The Phase2 programme was used in the numerical analyses, and the Strength Reduction Factors (SRF) of the slopes were determined. According to the numerical stability analyses, the failure mode for the portal slope is composite starting with a circular surface and following a linear surface and circular for the cut slope. The stability analyses indicated that the failure mechanism was not directly controlled by the joints and might be related to the low strength parameters of the rock mass and joints. Finally, precautions were determined to make the region stable using the Phase2 programme. After support installation, the SRF values for the portal and cut slopes increased from 1.21 to 1.63 and from 1.32 to 1.71, respectively. These results showed that the proposed support units prevent the effects of failure and were essential for the long-term stability.
Similar content being viewed by others
References
Akgun A (2011) Assessment of possible damaged areas due to landslide-induced waves at a constructed reservoir using empirical approaches: Kurtun (North Turkey) dam reservoir area. Nat Hazards Earth Syst Sci 11(5):1341–1350
Akgun A, Bulut F (2007) GIS-based landslide susceptibility for Arsin-Yomra (Trabzon, North Turkey) region. Environ Geol 51:1377–1387
Akgun A, Dag S, Bulut F (2008) Landslide susceptibility mapping for a landslide-prone area (Fındıklı, NE of Turkey) by likelihood-frequency ratio and weighted linear combination models. Environ Geol 54:1127–1143
Alemdag S, Kaya A, Karadag M, Gurocak Z, Bulut F (2013) Utilization of limit equilibrium method for the stability analysis of debris: an example of the Kalebasi District (Gumushane). Cumhur Earth Sci J 30(2):49–62
Alemdag S, Akgun A, Kaya A, Gokceoglu C (2014) A large and rapid planar failure: causes, mechanism and consequences (Mordut, Gumushane, Turkey). Arab J Geosci 7:1205–1221
Alemdag S, Kaya A, Karadag M, Gurocak Z, Bulut F (2015) Utilization of the limit equilibrium and finite element methods for the stability analysis of the slope debris: an example of the Kalebasi district (NE Turkey). J Afr Earth Sc. doi:10.1016/j.jafrearsci.2015.03.010
Barton N, Bandis SC (1990) Review of predictive capabilities of JRC-JCS model in engineering practice. Proc Int Symp Rock Joints, Loen 1990:603–610
Bulut F, Boynukalın S, Tarhan F, Ataoglu E (2000) Reliability of landslide ısopleth maps. Bull Eng Geol Environ 58:95–98
CANMET (1977) Pit slope manual: supplement 5-1, plane shear analysis. Canada centre for mineral and energy technology report. 16–77
Deere DU (1964) Technical description of rock cores for engineering purposed. Rock Mech Rock Eng 1:17–22
Eberhardt ED (2003) Rock slope stability analysis–utilization of advanced numerical techniques. Earth and Ocean sciences at UBC
Genc S (1993) Structural and geomorphological aspects of the Catak landslide, NE Turkey. Q J Eng Geol Hydrogeol 26(2):99–108
Griffiths DV, Lane PA (1999) Slope stability analysis by finite elements. Geotechnique 49(3):387–403
Gurocak Z, Alemdag S, Zaman M (2008) Rock slope stability and excavatability assessment of rocks at the Kapikaya dam site Eastern Turkey. Eng Geol 96(1–2):17–27
Guven IH (1993) 1:250000-scaled geology and compilation of the Eastern Pontide. General directorate of mineral research and exploration (MTA) of Turkey, Ankara. (unpublished)
Hammah RE, Yacoub TE, Curran JH (2006) Investigating the performance of the shear strength reduction (SSR) method on the analysis of reinforced slopes. In: Proceedings of the 59th Canadian geotechnical conference, Vancouver
Hoek E, Bray JW (1981) Rock slope engineering. Institution of Mining and Metallurgy, London
Hoek E, Diederichs MS (2006) Empirical estimation of rock mass modulus. Int J Rock Mech Min Sci 43:203–215
Hoek E, Marinos P (2000) Predicting tunnel squeezing. Tunnels and tunnelling international 1-32(11):45–51, 2-32(12):34–36
Hoek E, Carranza-Torres C, Corkum B (2002) Hoek-Brown failure criterion-2002 edition. In: Proceedings of NARMS-TAC2002, mining innovation and technology, Toronto, Canada, 267–273
ISRM (2007) The complete ISRM suggested methods for rock characterization, testing and monitoring: 1974–2006. International Society of Rock Mechanics Turkish National Group, Ankara
Karaman K (2013) Evaluation of rock slope stability by different methods (Unye, Ordu). J Geol Eng 37:27–47
Karaman K, Ercikdi B, Kesimal A (2013) The assessment of slope stability and rock excavatability in a limestone quarry. Earth Sci Res J 17:169–181
Karsli F, Atasoy M, Yalcin A, Reis S, Demir O, Gokceoglu C (2009) Effects of land-use changes on landslides in a landslide-prone area (Ardesen, Rize, NE Turkey). Environ Monit Assess 156:241–255
Kaya A (2008) The geotechnical ınvestigation of the left tube’s entrance portal of the Konakönü (Araklı-Trabzon) tunnel. MSc Thesis, Karadeniz Technical University, Trabzon
Kaya A, Bulut F, Alemdag S (2011a) Applicability of excavatability classification systems in underground excavations: a case study. Sci Res Essays 6(25):5331–5341
Kaya A, Bulut F, Alemdag S, Sayin A (2011b) Analysis of support requirements for a tunnel portal in weak rock: a case study in Turkey. Sci Res Essays 6(31):6566–6583
Kentli B, Topal T (2004) Assessment of rock slope stability for a segment of the Ankara-Pozanti motorway, Turkey. Eng Geol 74:73–90
Kesimal A, Ercikdi B, Cihangir F (2008) Environmental impacts of blast-induced acceleration on slope instability at a limestone quarry. Environ Geol 54:381–389
Kliche CA (1999) Rock slope stability. SME, Littleton
Li X (2007) Finite element analysis of slope stability using a nonlinear failure criterion. Comput Geotech 34:127–136
Mohr O (1900) Welche umstande bedingen die elastizitatsgrenze und den bruch eines materials? Zeit des Ver Deut Ing 44:1524–1530
Nefeslioglu H, Gokceoglu C (2011) Probabilistic risk assessment in medium scale for rainfall-ınduced earthflows: Cataklı catchment area (Cayeli, Rize, Turkey). Math Probl Eng 2011:1–21
Nefeslioglu H, Gokceoglu C, Sonmez H, Gorum T (2011) Medium-scale hazard mapping for shallow landslide ınitiation: the Buyukkoy catchment area (Cayeli, Rize, Turkey). Landslides 8:459–483
Osna T, Sezer AE, Akgun A (2014) GeoFIS: an ıntegrated tool for the assessment of landslide susceptibility. Comput Geosci 66:20–30
Reis S (2008) Analyzing land use/land cover changes using remote sensing and GIS in Rize, North-East Turkey. Sensors 8:6188–6202
Reis S, Yalcin A, Atasoy M, Nisancı R, Bayrak T, Erduran M, Sancar C, Ekercin S (2012) Remote sensing and GIS-based landslide susceptibility mapping using frequency ratio and analytical hierarchy methods in Rize province (NE Turkey). Environ Earth Sci 66:2063–2073
Rocscience (2004a) Dips v5.0 graphical and statistical analysis of orientation data. Rocscience Inc, Toronto
Rocscience (2004b) RocPlane v2.0 surface planar failure analysis. Rocscience Inc, Toronto
Rocscience (2004c) Swedge v4.0 surface wedge analysis. Rocscience Inc., Toronto
Rocscience (2007) Roclab v1.0 rock mass strength analysis using the generalized Hoek–Brown failure criterion. Rocscience Inc, Toronto
Rocscience (2008) Phase2 v7.0 finite element analysis for excavations and slopes. Rocscience Inc, Toronto
Shukra R, Baker R (2003) Mesh geometry effects on slope stability calculation by FLAC strength reduction method-linear and non-linear failure criteria. In: Brummer R et al (eds) Proceedings of the 3rd international FLAC symposium, Sudbury, Ontario, Canada, pp 109–116
Topsakal E, Topal T (2015) Slope stability assessment of a re-activated landslide on the Artvin-Savsat junction of a provincial road in Meydancik. Turk. Arab J Geosci 8(3):1769–1786
Turkish General Directorate of Highways (1997) List of specifications of the underground tunnel excavations with NATM practice (in Turkish). Turkish Ministry of Public Works, Ankara
Turkish General Directorate of Highways (2006) Specification for highway works (in Turkish). Turkish Ministry of Public Works, Ankara
Wyllie DC, Mah CW (2004) Rock slope engineering. Spon Press, NewYork
Yalcin A (2008) GIS-based landslide susceptibility mapping using analytical hierarchy process and bivariate statistics in Ardesen (Turkey): comparisons of results and confirmations. Catena 72:1–12
Yalcin A, Bulut F (2007) Landslide susceptibility mapping using GIS and digital photogrammetric techniques: a case study from Ardesen (NE-Turkey). Nat Hazards 41:201–226
Acknowledgments
Authors would like to express their sincerest gratitude to the editor and reviewers for their excellent comments. Also thanks to MSc. Geology Engineer Aytuna Sayin from the Turkish General Directorate of Highways for the office work associated with this study.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kaya, A., Akgün, A., Karaman, K. et al. Understanding the mechanism of slope failure on a nearby highway tunnel route by different slope stability analysis methods: a case from NE Turkey. Bull Eng Geol Environ 75, 945–958 (2016). https://doi.org/10.1007/s10064-015-0770-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10064-015-0770-5