Abstract
The complex behaviours of rocks and rock masses have presented paradoxes to the rock engineer, including the fracturing of seemingly strong rock under low stress conditions, which often occurs near excavation boundaries. The extension strain criterion was presented as a fracture initiation criterion under these conditions (Stacey in Int J Rock Mech Min Sci 18:469–474, 1981). This criterion has been used successfully by some and criticised by others. In this paper, we review the literature on the extension strain criterion and present a case for the correct interpretation of the criterion and the conditions suitable for its use. We argue that the extension strain criterion can also be used to provide an indication of damage level under conditions of relatively low confining stress. We also present an augmentation of the criterion, the ultimate extension strain, which is applicable under extensional loading conditions when σ 2 is similar in magnitude to σ 1.
Similar content being viewed by others
References
Alber M, Heiland J (2001a) Investigation of a limestone pillar failure part 1: geology, laboratory testing and numerical modeling. Rock Mech Rock Eng 34(3):167–186
Alber M, Heiland J (2001b) Investigation of a limestone pillar failure part 2: stress history and application of fracture mechanics approach. Rock Mech Rock Eng 34(3):187–199
Andersson JC, Martin CD, Stille H (2009) The Äspö pillar stability experiment: part II—Rock mass response to coupled excavation-induced and thermal-induced stresses. Int J Rock Mech Min Sci 46(5):879–895
Benz T, Schwab R, Kauther RA, Vermeer PA (2008) A Hoek–Brown criterion with intrinsic material strength factorization. Int J Rock Mech Min Sci 45:210–222
Bridgman PW (1912) Breaking tests under hydrostatic pressure and conditions of rupture. Philos Mag 24:63–80
Bridgman PW (1938) Reflections on rupture. J Appl Phys 9:517–528
Bridgman PW (1947) The effect of hydrostatic pressure on the fracture of brittle substances. J Appl Phys 18:246–258
Colmenares LB, Zoback MD (2002) A statistical evaluation of intact rock failure criteria constrained by polyaxial test data for five different rocks. Int J Rock Mech Min Sci 39:695–729
Cox SJD, Scholz CH (1988) On the formation and growth of faults: an experimental study. J Struct Geol 1988(10):413–430
Dyskin AV, Germanovich LN, Ustinov KB (1999) A 3-D model of wing crack growth and interaction. Eng Fract Mech 63:81–110. doi:10.1016/S0013-7944(96)00115-4
ELFEN (2006) Rockfield Software Ltd, 2006. Version 3.7.1
Fujii Y, Uehara Y (2006) A study on deformation and failure behaviour of rock subjected to axial extension under confining pressure. Shigen-to-Sozai 01 122:330–337
Fujii Y, Kiyama T, Ishijima Y (1997) Condition insensitive damage indicator for brittle rock. Int J Rock Mech Min Sci 34(3–4):086
Griffith AA (1920) The phenomena of rupture and flow in solids. Philos Trans R Soc Lond Ser A 221:163–198
Hadjiabdolmajid V, Kaiser PK, Martin CD (2002) Modelling brittle failure of rock. Int J Rock Mech Min Sci 39:731–741
Haimson B (2011) Consistent trends in the true triaxial strength and deformability of cores extracted from ICDP deep scientific holes on three continents. Tectonophysics 503(1):45–51. doi:10.1016/j.tecto.2010.10.011
Haimson B, Chang C (2000) A new true triaxial cell for testing mechanical properties of rock, and its use to determine rock strength and deformability of Westerly granite. Int J Rock Mech Min Sci 37:285–296
Haimson B, Chang C (2002) True triaxial strength of the KTB amphibolite under borehole wall conditions and its use to estimate the maximum horizontal in situ stress. J Geophys Res 107(B10): ETG 15, 1–14
Haimson B, Rudnicki JW (2010) The effect of the intermediate principal stress on fault formation and fault angle in sandstone. J Struct Geol 32:1701–1711
Jaeger JC, Cook NGW (1979) Fundamentals of rock mechanics, 3rd edn. Chapman & Hall, London
Joughin WC, Stacey TR (2005) Risks associated with rockpasses in deep-level tabular mines based on historical pass performance. J S Afr Inst Min Metall 105(11):795–802
Kwasniewski M, Takahashi M (2010) Strain-based failure criteria for rocks: state of the art and recent advances. In: Zhao J, Labiouse V, Dudt JP, Mathier JF (eds) Rock mechanics in civil and environmental engineering. Taylor & Francis Group, London, pp 45–56
Lee H, Haimson BC (2011) True triaxial strength, deformability, and brittle failure of granodiorite from the San Andreas Fault Observatory at Depth. Int J Rock Mech Min Sci 48:1199–1207
Li D, Wong LNY (2013) The Brazilian disc test for rock mechanics applications. Rock Mech Rock Eng 46:269–287
Li D, Li C, Li X (2011) Influence of sample height-to-width ratios on failure mode for rectangular prism samples of hard rock loaded in uniaxial compression. Rock Mech Rock Eng 44:253–267
Louchnikov V (2011) Simple calibration of the extension strain criterion for its use in numerical modelling. In: Potvin Y (ed) Strategic vs tactical approaches in mining. Australian Centre for Geomechanics, Perth, pp 85–96
Martin CD (1993) The strength of massive Lac du Bonnet granite around underground openings. Ph.D. Thesis, University of Manitoba
Minney DS (1990) Damage and remedial action taken to secure the Free State Saaiplaas No 3 Shaft on 1780 Level. In: Proc. Symp. Rock Instability Problems in Mine Shafts, S. Afr. Nat. Group of Int. Soc. Rock Mech., Potchefstroom, May 1990, pp 65–72
Mogi K (1967) The effect of the intermediate principal stress on rock failure. J Geophys Res 72:5117–5131
Mogi K (2007) Experimental rock mechanics. Taylor & Francis/Balkema, Leiden
Ndlovu X (2006) Three dimensional analyses of stress and strain distributions around bord and pillar geometries. M.Sc. Eng Dissertation, University of the Witwatersrand, 171p
Ndlovu X, Stacey TR (2007) Observations and analyses of roof guttering in a coal mine. J S Afr Inst Min Metall 107(8):477–492
Nicksiar M, Martin CD (2012) Evaluation of methods for determining crack initiation in compression tests on low-porosity rocks. Rock Mech Rock Eng 45(4):607–617
Oku H, Haimson B, Song S-R (2007) True triaxial strength and deformability of the siltstone overlying the Chelungpu Fault (Chi-Chi earthquake), Taiwan. Geophys Res Lett 34(L09):306
Ortlepp WD (1997) Rock fracture and rockbursts. S. Afr. Inst. Min. Metall., 255p
Pang SS, Goldsmith W (1990) Investigation of crack formation during loading of brittle rock. Rock Mech Rock Eng 23(1):53–63
Reches Z (1999) Mechanisms of slip nucleation during earthquakes. Earth Planet Sci Lett 170:475–486
Reches Z, Lockner DA (1994) Nucleation and growth of faults in brittle rocks. J Geophys Res 99(B9):18159–18173
Ryder JA, Jager AJ (2002) A textbook on rock mechanics for hard rock mines. SIMRAC, Safety in Mines Research Advisory Committee, South Africa
Sahouryeh E, Dyskin AV, Germanovich LN (2002) Crack growth under biaxial compression. Eng Fract Mech 69:2187–2198. doi:10.1016/S0013-7944(02)00015-2
Simmons JV (2011) Extensional deformation triggers for potential composite failure of bedded rock slopes. In: Slope Stability 2011, Proc. int. symp. on rock slope stability in open pit mining and civil engineering, Vancouver, Canada, 13p
Simmons JV, Simpson PJ (2007) Extension, stress and composite failure in bedded rock masses. In: Potvin Y (ed) Proc. int. symp. on rock slope stability in open pit mining and civil engineering. Australian Centre for Geomechanics, pp 213–223
Stacey TR (1981) A simple extension strain criterion for fracture of brittle rock. Int J Rock Mech Min Sci 18:469–474
Stacey TR (1982) Contribution to the mechanism of core discing. J S Afr Inst Min Metall 82(9):269–274
Stacey TR (1989) Boring in massive rocks—rock fracture problems. In: Proc. seminar on mechanised underground excavation, S. Afr. Nat. Council on Tunnelling, November 1989, pp 87–90
Stacey TR, de Jongh CL (1977) Stress fracturing around a deep level bored tunnel. J S Afr Inst Min Metall 78(5):124–133
Stacey TR, Harte ND (1989) Deep level raise boring—prediction of rock problems. In: Maury V, Fourmaintraux D, Balkema AA (eds) Proc. int. symp. rock at great depth, vol 2, pp 583–588
Stacey TR, Yathavan K (2003) Examples of fracturing at very low stress levels. In: Proc. 10th Int. Cong. Int. Soc. Rock Mech., Sandton, S. Afr. Nat. Inst. For Rock Engng and S. Afr. Inst. Min. Metall., vol 2, pp 1155–1159
Stacey TR, Yu X, Armstrong R, Keyter GJ (2003) New slope stability considerations for deep open pit mines. J S Afr Inst Min Metall 103(6):373–389
Stacey TR, Ortlepp WD, Ndlovu X (2007) Dynamic rock failures due to “high” stress at shallow depth. In: Proc 4th int. seminar on deep and high stress mining. Australian Centre for Geomechanics, Perth, pp 193–204
Steffanizzi S, Barla G, Kaiser PK (2007) Numerical modelling of strain driven fractures around tunnels in layered rock masses. In: Ribeiro, Olalla and Grossmann (eds) Proc. 11th Int. Cong. Int. Soc. Rock Mech. Taylor and Francis Group, London, pp 971–974
Takahashi M et al (2006) Hydro-mechanical behavior in sandstone during from brittle to ductile deformation and its relation to inner structural change. In: Eurock 2006: multiphysics coupling and long term behaviour in rock mechanics: Proceedings of the international symposium of the international society for rock mechanics, Eurock 2006, Liège, Belgium, 9–12 May 2006. CRC Press, Boca Raton, pp 155–161
Tarasov BG, Randolph MF (2011) Superbrittleness of rocks and earthquake activity. Int J Rock Mech Min Sci 48:888–898
Waldeck HG (1979) The design and support of large underground chambers at depth in the mines of the Gold Fields Group of South Africa. In: Proc. 4th Int. Cong. Int. Soc. Rock Mech., Montreux, vol 1, pp 565–571
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wesseloo, J., Stacey, T.R. A Reconsideration of the Extension Strain Criterion for Fracture and Failure of Rock. Rock Mech Rock Eng 49, 4667–4679 (2016). https://doi.org/10.1007/s00603-016-1059-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00603-016-1059-0