Skip to main content
Log in

Angle compensation of the reference beam in a retrieving process of the holographic data storage system

  • Technical Paper
  • Published:
Microsystem Technologies Aims and scope Submit manuscript

Abstract

Holographic data storage system is one of a strong candidate of the next generation high capacity data storage system with a high storage density and a fast data transfer rate. The holographic data storage system uses two beams in a recording process and only a reference beam is used for retrieving stored data. With the angle multiplexing when the angle of the reference beam is deviated from its correct point, the diffraction efficiency of the corresponding data page is reduced and SNR is decreased. Therefore it is necessary to compensate the angle of the reference beam to reconstruct a good data page. To compensate the angle error, the angle of the reference beam is changed precisely within a specific range and stopped at the angle with the highest diffraction efficiency. By this method, in a retrieving process if there is a difference between the real angle of the reference beam and its correct angle, the error can be compensated and the best data page can be obtained.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

  • Coufal HJ, Psaltis D, Sincerbox GT (2000) Holographic data storage. Springer, New York

    MATH  Google Scholar 

  • Haykin S (1998) Neural network. Pearson US Imports & PHIPEs, USA

    Google Scholar 

  • Kogelnik H (1969) Coupled wave theory for thick hologram gratings. Bell Syst Tech J 48(9):2909–2947

    Google Scholar 

  • Li H-YS, Psaltis D (1994) Three dimensional holographic disks. Appl Opt 33(17):3764–3774

    Google Scholar 

  • Li H-YS, Psaltis D (1995) Alignment sensitivity of holographic three-dimensional disks. J Opt Soc Am A 12(9):1902–1912

    Google Scholar 

  • Mok FH (1993) Angle-multiplexed storage of 5,000 holograms in lithium niobate. Opt Lett 18:915–917

    Google Scholar 

  • Rastani K (1993) Storage capacity and cross talk in angularly multiplexed holograms: two case studies. Appl Opt 32(20):3772–3778

    Article  Google Scholar 

Download references

Acknowledgment

This research was supported by the MOCIE (Ministry of Commerce, Industry and Energy) of Korea through the program for the Next Generation Ultra-High Density Storage (00008145).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Hyunseok Yang.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kim, SH., Kim, J.H., Yang, J. et al. Angle compensation of the reference beam in a retrieving process of the holographic data storage system. Microsyst Technol 13, 1403–1410 (2007). https://doi.org/10.1007/s00542-007-0379-0

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00542-007-0379-0

Keywords

Navigation