Abstract
Dynamic mechanical thermal analysis has been used to monitor the change in wood veneer stiffness due to furfuryl alcohol impregnation and plasticization of wood components and subsequent polymerization of furfuryl alcohol within wood material. This explains the improvement in the moulding ability of wood veneer where furfuryl alcohol aids in wood plasticization, and the increase in moulded shape stability achieved when furfuryl alcohol is polymerised within wood cell walls.
Similar content being viewed by others
References
Blechschmidt J, Engert P, Stephan M (1968) The glass transition of wood from the viewpoint of mechanical pulping. Wood Sci Technol 20(3):263–272
Guigo N, Mija A, Vincent L, Sbirrazzuoli N (2007) Chemorheological analysis and model-free kinetics of acid catalysed furfuryl alcohol polymerization. Phys Chem Chem Phys 9(39):5359–5366
Herold N, Pfriem A (2013) Impregnation of veneer with furfuryl alcohol for an improved plasticization and moulding. Eur J Wood Prod 71(2):281–282
Herold N, Pfriem A (2014) Shape retention of furfurylated and moulded wood veneer. BioRes 9(1):545–553
Herold N, Dietrich T, Grigsby WJ, Franich RA, Buchelt B, Pfriem A (2013) Effect of maleic anhydride content and ethanol dilution on the polymerization of furfuryl alcohol in wood veneer studied by differential scanning calorimetry. BioRes 8(1):1064–1075
Lenth C, Sargent R (2008) Wood material behavior during drying: moisture-dependent tensile stiffness and strength of Radiata pine at 70–150 °C. Dry Technol 26(9):1112–1117
Menard KP (2008) Dynamic mechanical analysis: a practical introduction. CRC Press, Boca Raton
Schneider MH (2002) Furan polymer impregnated wood, method for preparing the polymer and uses thereof. Patent WO 2002030638:A2
Schuerch C (1966) Method of forming wood and formed wood products. Patent US 3(282):313
Wagenführ A, Buchelt B (2005) Untersuchungen zum Materialverhalten beim dreidimensionalen Formen von Furnier (investigations to the material behaviour during three dimensional forming of veneer). Holztechnologie 46(1):13–19
Acknowledgments
The authors are grateful for the financial support of the German Research Foundation (DFG, Grant No. PF 686/4-1), COST (STSM-RA-New Zealand-06283) and the provision of resources provided by Scion. We are also greatly appreciative for the gift of furfuryl alcohol by International Furan Chemicals B.V.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Herold, N., Grigsby, W.J., Franich, R.A. et al. Investigations of wood veneer during furfuryl alcohol modification using DMTA. Eur. J. Wood Prod. 73, 693–695 (2015). https://doi.org/10.1007/s00107-015-0941-x
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00107-015-0941-x