Abstract
Phase transformations in ceramics of the ZrO2−Y2O3−Al2O3 system that occur in mechanical and heat treatment are considered. The effect of the surface purity on the phase composition is described. It is shown that a tetragonal-rhombohedral transformation occurs under stress applied to the treated surface.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
T. Sakuma, Y. Yoshizawa, and H. Suto, “The rhombohedral phase produced in partially-stabilized zirconia,”Mater. Sci. Lett.,4(1), 29–30 (1985).
Y. Kitano, Y. Mori, A. Ischitani, and T. Masaki, “A study of the rhombohedral phase in Y2O3 partially stabilized zirconia,”Mater. Res. Soc. Symp. Proc.,78, 17–24 (1987).
F. Reidinger and P. J. Whalen, “Texture of ground, fractured, and aged Y-TZP surfaces,”Mater. Res. Soc. Symp. Proc.,78, 25–33 (1987).
N. L. Savchenko, T. Yu. Sablina, T. M. Poletika, et al., “Phase composition and mechanical properties of zirconia-base ceramics obtained by high-temperature sintering in vacuum,”Poroshk. Metallurg., Nos, 9-10, 96–100 (1993).
Additional information
Translated from Steklo i Keramika, No. 10, pp. 16–17, October, 1996.
Research Institute of Problems of Powder Technology and Coatings.
Rights and permissions
About this article
Cite this article
Sevast'yanova, I.G., Klimov, L.A. & Zabolotskikh, S.A. Phase transformations in mechanical and heat treatment of ceramics in the ZrO2−Y2O3−Al2O3 system. Glass Ceram 53, 301–302 (1996). https://doi.org/10.1007/BF01130795
Issue Date:
DOI: https://doi.org/10.1007/BF01130795