Journal of Thermal Spray Technology

, Volume 7, Issue 1, pp 43–46

Thermal Conductivity of a Zirconia Thermal Barrier Coating

Authors

  • A.J. Slifka
    • Materials Reliability Division, National Institute of Standards and Technology
  • B.J. Filla
    • Materials Reliability Division, National Institute of Standards and Technology
  • J.M. Phelps
    • Materials Reliability Division, National Institute of Standards and Technology
  • G. Bancke
    • Thermal Spray Laboratory, Materials Science and Engineering, State University of New York at Stony Brook
  • C.C. Berndt
    • Thermal Spray Laboratory, Materials Science and Engineering, State University of New York at Stony Brook
Article

DOI: 10.1007/s11666-006-5001-y

Cite this article as:
Slifka, A., Filla, B., Phelps, J. et al. J Therm Spray Tech (1998) 7: 43. doi:10.1007/s11666-006-5001-y

Abstract

The conductivity of a thermal-barrier coating composed of atmospheric plasma sprayed 8 mass percent yttria partially stabilized zirconia has been measured. This coating was sprayed on a substrate of 410 stainless steel. An absolute, steady-state measurement method was used to measure thermal conductivity from 400 to 800 K. The thermal conductivity of the coating is 0.62 W/(m×K). This measurement has shown to be temperature independent.

Copyright information

© ASM International 1998