Journal of Nanoparticle Research

, Volume 9, Issue 5, pp 725–735

Transport of surface-modified iron nanoparticle in porous media and application to arsenic(III) remediation

Authors

  • Sushil Raj Kanel
    • Department of Environmental Science and EngineeringGwangju Institute of Science and Technology (GIST)
  • Dhriti Nepal
    • Department of Materials Science and EngineeringGwangju Institute of Science and Technology (GIST)
  • Bruce Manning
    • Department of Chemistry and BiochemistrySan Francisco State University
    • Department of Environmental Science and EngineeringGwangju Institute of Science and Technology (GIST)
Research Paper

DOI: 10.1007/s11051-007-9225-7

Cite this article as:
Kanel, S.R., Nepal, D., Manning, B. et al. J Nanopart Res (2007) 9: 725. doi:10.1007/s11051-007-9225-7

Abstract

The surface-modified iron nanoparticles (S-INP) were synthesized, characterized and tested for the remediation of arsenite (As(III)), a well known toxic groundwater contaminant of concern. The S-INP material was fully dispersed in the aqueous phase with a particle size distribution of 2–10 nm estimated from high-resolution transmission electron microscopy (HR-TEM). X-ray photoelectron spectroscopy (XPS) revealed that an Fe(III) oxide surface film was present on S-INP in addition to the bulk zero-valent Fe0 oxidation state. Transport of S-INP through porous media packed in 10 cm length column showed particle breakthroughs of 22.1, 47.4 and 60 pore volumes in glass beads, unbaked sand, and baked sand, respectively. Un-modified INP was immobile and aggregated on porous media surfaces in the column inlet area. Results using S-INP pretreated 10 cm sand-packed columns containing ∼2 g of S-INP showed that 100 % of As(III) was removed from influent solutions (flow rate 1.8 mL min−1) containing 0.2, 0.5 and 1.0 mg L−1 As(III) for 9, 7 and 4 days providing 23.3, 20.7 and 10.4 L of arsenic free water, respectively. In addition, it was found that 100% of As(III) in 0.5 mg/L solution (flow rate 1.8 mL min−1) was removed by S-INP pretreated 50 cm sand packed column containing 12 g of S-INP for more than 2.5 months providing 194.4 L of arsenic free water. Field emission scanning electron microscopy (FE-SEM) showed S-INP had transformed to elongated, rod-like shaped corrosion product particles after reaction with As(III) in the presence of sand. These results suggest that S-INP has great potential to be used as a mobile, injectable reactive material for in-situ sandy groundwater aquifer treatment of As(III).

Keywords

NanoparticlesSurfactantsArsenicIn-situ treatmentEnvironmental remediation

Copyright information

© Springer Science+Business Media, Inc. 2007