Abstract
The near-ternary eutectic Sn-Ag-Cu alloys have been identified as leading Pb-free solder candidates to replace Pb-bearing solders in microelectronic applications. However, recent investigations on the processing behavior and solder joints reliability assessment have revealed several potential reliability risk factors associated with the alloy system. The formation of large Ag3Sn plates in Sn-Ag-Cu joints, especially when solidified in a relatively slow cooling rate, is one issue of concern. The implications of large Ag3Sn plates on solder joint performance and several methods to control them have been discussed in previous studies. The minor Zn addition was found to be effective in reducing the amount of undercooling required for tin solidification and thereby to suppress the formation of large Ag3Sn plates. The Zn addition also caused the changes in the bulk microstructure as well as the interfacial reaction. In this paper, an in-depth characterization of the interfacial reaction of Zn-added Sn-Ag-Cu solders on Cu and Au/Ni(P) surface finishes is reported. The effects of a Zn addition on modification of the interfacial IMCs and their growth kinetics are also discussed.
Article PDF
Similar content being viewed by others
References
NCMS Lead-Free Solder Project Final Report (Ann Arbor, MI: NCMS, 1997).
P.T. Vianco and C. May, “An Evaluation of Prototype Surface Mount Circuit Boards Assembled with Three Non-Lead Bearing Solders,” Proceedings of SMI ’95, (Edina, MN: SMTA, 1995), pp. 481–494.
NCMS High-Temperature Fatigue-Resistant Solder Project, Final Report (Ann Arbor, MI: NCMS, 2001).
Lead-Free Roadmap (Tokyo, Japan: Japan Electronics and Information Technology Industries Association (JEITA), 2002).
J. Bath, C. Handwerker, and E. Bradley, Circuits Assembly 11, 45 (2000).
I.E. Anderson, J.C. Foley, B.A. Cook, J. Harringa, R.K. Terpstra, and O. Unal, J. Electron. Mater. 29, 1050 (2001).
K.J. Puttlitz, “Sn-Ag, and Sn-Ag-X Solders and Properties,” Handbook of Lead-Free Solder Technology for Microelectronic Assemblies, ed. K.J. Puttlitz, K.A. Stalter (New York: Marcel Dekker, Inc., 2004), pp. 239–280.
S.K. Kang, “Bi-Sn, Sn-Sb, Sn-Cu, Sn-Zn, and Sn-In Solder-Based Systems and Their Properties,” Handbook of Lead-Free Solder Technology for Microelectronic Assemblies, ed. K.J. Puttlitz, K.A. Stalter (New York: Marcel Dekker, Inc., 2004), pp. 281–300.
S.K. Kang, R.S. Rai, and S. Purushothaman, J. Electron. Mater. 25 (7), 1113 (1996).
S.K. Kang et al., IEEE Trans. Electron. Packag. Manuf., 25 (2), 1 (2002).
I.E. Anderson, B.A. Cook, J. Harringa, and R.L. Terpstra, J. Electron. Mater. 31, 1166 (2002).
I.E. Anderson and J.L. Harringa, J. Electron. Mater. 33 (12), 1485 (2004).
W.K. Choi, S.K. Kang, and D.Y. Shih, J. Electron. Mater. 31 (11), 1283 (2002).
W.K. Choi, S.K. Kang, Y.C. Sohn, and D.Y. Shih, Proc. 53rd Electronic Components and Technology Conf. (Piscataway, NJ: IEEE, 2003), pp. 1190–1196.
Y.C. Sohn, J. Yu, S.K. Kang, D.Y. Shih, and T.Y. Lee, Proc. 54th Electronic Components and Technology Conf. (Piscataway, NJ: IEEE, 2004), pp. 75–81.
S.K. Kang, W.K. Choi, D.Y. Shih, P. Lauro, D.W. Henderson, T. Gosselin, and D.N. Leonard, Proc. 52nd ECTC, pp. 147–153.
S.K. Kang, D.Y. Shih, D. Leonard, D.W. Henderson, T. Gosselin, S. Cho, J. Yu, and W.K. Choi, JOM 56 (6), 34 (2004).
D.W. Henderson, T. Gosselin, A. Sarkhel, S.K. Kang, W.K. Choi, D.Y. Shih, C. Goldsmith, and K. Puttlitz, J. Mater. Res. 17 (11), 2775 (2002).
S.K. Kang, W.K. Choi, D.Y. Shih, D.W. Henderson, T. Gosselin, A. Sarkhel, C. Goldsmith, and K. Puttlitz, Proc. 53rd ECTC (Piscataway, NJ: IEEE, 2003), pp. 64–70.
S.K. Kang, W.K. Choi, D.Y. Shih, D.W. Henderson, T. Gosselin, A. Sarkhel, C. Goldsmith, and K. Puttlitz, JOM 55 (6), 61 (2003).
K.L. Buckmaster et al., “The Effects of Minor Zn Alloying Additions on the Solidification Behavior and Microstructure of Near-Eutectic Sn-Ag-Cu Solder Joints,” (Paper presented at the 2003 TMS Fall Meeting, Chicago, IL, November 2003).
T.C. Chiu, K. Zeng, R. Stierman, D. Edwards, and K. Ano, Proc. 54th ECTC (Piscataway, NJ: IEEE, 2004), pp. 1256–1262.
M. Date, T. Shoji, M. Fujiyoshi, K. Sato, and K.N. Tu, Proc. 54th ECTC (Piscataway, NJ: IEEE, 2004), pp. 668–674.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Kang, S.K., Leonard, D., Shih, DY. et al. Interfacial reactions of Sn-Ag-Cu solders modified by minor Zn alloying addition. J. Electron. Mater. 35, 479–485 (2006). https://doi.org/10.1007/BF02690535
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02690535