Abstract
This paper reports on the results of a comparative investigation into the physical, mechanical, and tribological characteristics of Ti-(Ca,Zr)-(C,N,O,P) coatings. The hardness, elastic modulus, elastic recovery, adhesion strength, friction coefficient, and wear rate of the coatings are determined. The specific features revealed in the deformation and fracture of the coatings deposited on various substrates in the course of adhesion tests are described. It is shown that the critical loads responsible for different types of adhesion and cohesion failure of the coatings can be determined from a set of parameters obtained during their scratching. The features observed in the behavior of the friction characteristics of the coatings during tribological tests in air and in a physiological solution are discussed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
D. V. Shtanskiĭ, S. A. Kulinich, E. A. Levashov, and J. J. Moore, Fiz. Tverd. Tela (St. Petersburg) 45(6), 1122 (2003) [Phys. Solid State 45 (6), 1177 (2003)].
F. V. Kiryukhantsev-Korneev, D. V. Shtanskiĭ, A. N. Sheveĭko, E. A. Levashov, I. V. Lyasotskiĭ, and N. B. D’yakonova, Fiz. Met. Metalloved. 97(3), 96 (2004) [Phys. Met. Metallogr. 97 (3), 314 (2004)].
D. V. Shtansky, S. A. Kulinich, E. A. Levashov, A. N. Sheveiko, F. V. Kiriuhancev, and J. J. Moore, Thin Solid Films 420–421, 330 (2002).
R. A. Andrievskiĭ, G. V. Kalinnikov, N. P. Kobelev, Ya. M. Soĭfer, and D. V. Shtanskiĭ, Fiz. Tverd. Tela (St. Petersburg) 39(10), 1859 (1997) [Phys. Solid State 39 (10), 1661 (1997)].
D. V. Shtansky, N. A. Glushakova, A. N. Sheveiko, M. A. Kharitonova, T. G. Moizhess, O. V. Malochkin, E. A. Levashov, and F. Rossi, Biomaterials 26, 2909 (2005).
D. V. Shtansky, E. A. Levashov, N. A. Glushankova, N. B. D’yakonova, S. A. Kulinich, M. I. Petrzhik, F. V. Kiryukhantsev-Korneev, and F. Rossi, Surf. Coat. Technol. 182, 101 (2004).
D. V. Shtansky, in NATO Science Series II: Mathematics, Physics, and Chemistry, Vol. 155: Nanostructured Thin Films and Nanodispersion Strengthened Coatings, Ed. by A. A. Voevodin, D. V. Shtansky, E. A. Levashov, and J. J. Moore (Kluwer, Dordrecht, Netherlands, 2004), p. 155.
D. V. Shtanskiĭ, E. A. Levashov, N. A. Glushankova, I. V. Lyasotskiĭ, and F. Rossi, Fiz. Met. Metalloved. 97(5), 34 (2004) [Phys. Met. Metallogr. 97 (5), 460 (2004)].
D. V. Shtanskiĭ, N. A. Glushankova, I. A. Bashkova, M. A. Kharitonova, T. G. Moĭzhess, A. N. Sheveĭko, F. V. Kiryukhantsev-Korneev, M. I. Petrzhik, E. A. Levashov, and F. Rossi, Izv. Vyssh. Uchebn. Zaved., Tsvetn. Metall., No. 6, 66 (2004).
R. A. Andrievskiĭ, G. V. Kalinnikov, N. Hellgren, P. Sandstrom, and D. V. Shtanskiĭ, Fiz. Tverd. Tela (St. Petersburg) 42(9), 1624 (2000) [Phys. Solid State 42 (9), 1671 (2000)].
D. V. Shtanskiĭ, F. V. Kiryukhantsev-Korneev, A. N. Sheveĭko, I. A. Bashkova, O. V. Malochkin, E. A. Levashov, N. B. D’yakonova, and I. V. Lyasotskiĭ, Fiz. Tverd. Tela (St. Petersburg) 47(2), 242 (2005) [Phys. Solid State 47 (2), 252 (2005)].
M. I. Petrzhik, D. V. Shtanskiĭ, and E. A. Levashov, in Proceedings of the X International Scientific-Practical Conference “High Technologies in Industry of Russia” and XVI International Symposium “Thin Films for Electronics” (OAO TsNITI “TEKhNOMASh,” Moscow, 2004), p. 311 [in Russian].
I. G. Brown, Rev. Sci. Instrum. 65, 3061 (1994).
E. A. Levashov, A. S. Rogachev, V. I. Yukhvid, and I. P. Borovinskaya, Physicochemical and Technological Principles of Self-Propagating High-Temperature Synthesis (Binom, Moscow, 1999), p. 134 [in Russian].
G. M. Pharr, W. C. Oliver, and F. R. Brotzen, J. Mater. Res. 3, 613 (1992).
I. M. Hutchings, Tribology: Friction and Wear of Engineering Materials (Edward Arnold, London, 1992), p. 20.
J. L. Arias, M. B. Mayor, J. Pou, Y. Leng, B. Leon, and M. Perez-Amor, Biomaterials 24, 3403 (2003).
Shape Memory Alloys, Ed. by H. Funakubo (Gordon and Breach, New York, 1987; Metallurgiya, Moscow, 1990).
M. I. Petrzhik and S. G. Fedorov, in Proceedings of the XVI Conference on Applied Crystallography (World Scientific, Singapore, 1995), p. 273.
M. Pang and D. F. Bahr. J. Mater. Res. 16(9), 2634 (2001).
W. C. Oliver and G. M. Pharr, J. Mater. Res. 7, 1564 (1992).
R. A. Andrievskiĭ and I. I. Spivak, Strength of Refractory Compounds and Materials on Their Basis: A Handbook (Metallurgiya, Chelyabinsk, 1989) [in Russian].
L. Karlsson, L. Hultman, M. P. Johnsson, J.-E. Sundgren, and H. Ljungcrantz, Surf. Coat. Technol. 126, 1 (2000).
A. Leyland and A. Matthews, Wear 246, 1 (2000).
T. Y. Tsui, G. M. Pharr, W. C. Oliver, C. S. Bhatia, R. L. White, S. Anders, A. Andres, and I. G. Brown, Mater. Res. Soc. Symp. Proc. 383, 447 (1996).
E. Badisch, G. A. Fontalvo, and C. Mitterer, Wear 256, 95 (2004).
Author information
Authors and Affiliations
Additional information
Original Russian Text © D.V. Shtansky, M.I. Petrzhik, I.A. Bashkova, F.V. Kiryukhantsev-Korneev, A.N. Sheveĭko, E.A. Levashov, 2006, published in Fizika Tverdogo Tela, 2006, Vol. 48, No. 7, pp. 1231–1238.
Rights and permissions
About this article
Cite this article
Shtansky, D.V., Petrzhik, M.I., Bashkova, I.A. et al. Adhesion, friction, and deformation characteristics of Ti-(Ca,Zr)-(C,N,O,P) coatings for orthopedic and dental implants. Phys. Solid State 48, 1301–1308 (2006). https://doi.org/10.1134/S1063783406070146
Received:
Issue Date:
DOI: https://doi.org/10.1134/S1063783406070146